Apply liquid
Shake the bottle first so the formula is evenly mixed, then apply generously to the sandy area. Do not add water to the inside of the bottle.
Directions for use
Four steps, about a minute from start to finish. Here is exactly what the SandGoGo label says to do — and why each step matters.
Shake the bottle first so the formula is evenly mixed, then apply generously to the sandy area. Do not add water to the inside of the bottle.
Work the formula across the whole sandy area — the tops of the feet, between the toes, ankles and anywhere else sand has collected. An even layer dries and lifts more cleanly than a thick patch.
The label calls for about 30 seconds of drying time. This is the step that does the work: as the layer dries it sets around the sand grains so they come away together instead of one at a time.
Clap your hands against the skin, tap, or brush with a hand or towel. Because SandGoGo dries into a layer rather than staying a loose powder, it flakes off downward — carrying the sand back to the beach where it belongs, instead of drifting into the air around you. It comes away clean and does not stick to the skin — no tacky film, nothing to wash off afterwards. No rinse station, no water bottle, no soaked car mat.
Always read and follow the directions and cautions printed on the bottle you receive. The bottle label is the authoritative version.
A note on expectations. SandGoGo is designed to help release beach sand from skin. It is not a sunscreen, a cleanser or a substitute for washing, and results depend on how much sand is present, how wet the skin is and how evenly the layer is applied and dried.
Free shipping in the United States and a 30-day satisfaction guarantee.